Beko BEKOMAT 8, Инструкция по установке и эксплуатации

Страница: 15 / 28

EN
Installation and operation manual
BEKOMAT
®
8/9 15
3.2. Installation steps
The following illustrations show possible assembly of the BEKOMAT
®
8/9 .
NOTE Assembly instructions
• Install a separate BEKOMAT
®
at each point where condensate occurs.
• Do not use any tapered threaded joints.
• Keep pipe length as short as possible.
•
Do not fit a filter/dirt trap into the condensate inlet.
• Only use ball valves for the condensate inlet.
• The venting line must be above the max. possible condensate level.
• Observe minimum assembly heights
Installation BEKOMAT
®
8/9
Venting A:
Install line ≥ 3/4" with ball valve
Condensate inlet B:
Install pipe ≥ 2" (DN 50) with flange and ball valve:
• Short feed line!
• Slope of the condensate inlet > 1 %!
•
No filter in the condensate inlet!
Condensate discharge C:
Install line ≥ 1"
(≥ 2" for
BEKOMAT
®
9):
• Do not route into a manifold!
• Max. 5 m incline!
• The minimum operating pressure increases by 0.1 bar
per metre of incline!
For maintenance purposes:
Manual condensate drain D:
• Install ≥ 3/4" with ball valve
Bypass line E:
• Install ≥ 1" with ball valve
B
A
C
D
E