Page
9 ©
BEKA 2019 All rights reserved!
...a product of
5.
General safety instructions
Everybody who is in charge of the assembly, start-up, maintenance and operation of the device must read these instructions carefully
prior to assembly and start-up of the device at the machine! Furthermore, this manual must always be available at the site of operation!
Basic instructions for setup, operation and maintenance can be found below.
5.1 Safety
instructions
Observe the general safety instructions within this key chapter as well as the special safety instructions in other chapters of this
operating and assembly manual.
Warning of electrical voltage.
Safety instructions, which might cause hazards to persons in case of non-observance, are marked with the general
danger symbol.
This symbol warns of hot surfaces.
Warning of suspended loads.
Warning of material damage due to electrostatic discharge! Marks potential risks which may result in material damage,
if not avoided.
This heading is used if improper or general non-observance of the operating and assembly manual,
instructions, specified workflow and the like might result in damage.
This term is used to point out particular details.
Instructions and notes directly attached to the device have to be strictly observed and kept in readable condition!
5.2
Qualification and training of staff
The staff in charge of operation, maintenance, inspection and assembly have to be qualified accordingly. Competence,
responsibilities and supervision of staff must be clearly defined by the operator. In case the staff does not have the
necessary knowledge it has to be instructed and trained accordingly. The operator is obliged to ensure that the staff
fully understands the contents of this user information.
Notice!
Caution!
