Page
14 ©
BEKA 2019 All rights reserved!
...a product of
9.
Assembly instructions
Check the device for possible transport damage and for completeness before the assembly. Any installed equipment for transportation
safety has to be removed.
Comply with the following conditions when assembling a complete machine from this device and other components.
Mind a proper and eco-friendly assembly without impairment of persons’ health and safety:
Assemble the device in balance on the installation location in order to ensure safe operation. Observe the information on the fastening
holes given in the dimensional drawing. When selecting the set-up location, please mind that the device should be protected against
ambient and mechanic influences. Ensure full access, e.g. for filling with lubricant.
Special measures concerning noise prevention or oscillation reduction do not have to be taken.
9.1
Prefilling of return connection (lubricant)
This chapter must only be observed when the return connection for the lubricant is used. If the device is
operated without this option, continue with chapter 9.2.
In order to avoid that air is pumped into the container / barrel, when the lubricant flows back, the return connection in the pump pipe
must be prefilled with lubricant.
Always ensure
utmost cleanliness
during the
prefilling
.
Step 1:
If the return connection (fig. 10, pos. 1) is sealed, the screw plug (fig. 10, pos. 2) has to be unscrewed with an Allen key AF10.
The return connection is marked with an „R“ at the pump (fig. 11).
Notice!
1
2
Caution!
Notice!
Figure 10
Figure 11
