Service menu
Note:
This option is only available on X2 panels, with the exception of X2 base
Note:
If the operator panel contains a CODESYS Runtime, then the CODESYS Runtime must be
downloaded once again to the panel after the panel image has been changed.
3.6 Self test
The self test screen looks a little different depending on operator panel type.
To be able to fully test the Carrier unit, a complete set of test plugs, SD card and a
USB flash drive is needed.
3.7 Touch calibrate
The touch calibration screen enables the function to recalibrate the touch screen.
The recalibration consists of five steps, where a crosshair on the screen is pressed
and held. Take care and try to do this as precise as possible, an incorrect calibration
makes it hard to use the operator panel.
3.8 Debug logging
The Debug Logging dialog enables the function
to enable and disable the debug logging on the
operator panel. It also enables the function to move
a previously created set of debug log files from the
operator panel to an USB flash drive.
Beijer Electronics, MAEN205G
12
