Safety Precautions
Warning:
Battery may explode if mistreated. Do not recharge, disassemble or dispose
of in fire.
LA BATTERIE PEUT EXPLOSER EN CAS DE MAUVAISE MANIPULATION.
NE LA RECHARGEZ PAS, NE LA DÉMONTEZ PAS ET NE LA JETEZ
PAS DANS LE FEU.
•
This product contains a battery; this must only be changed in an area known
to be non-hazardous.
•
Replace the battery with a BR 2032 battery. Use of another type of battery
may present a risk of fire or explosion.
•
For use on a flat surface of a type 4X enclosure indoor use only.
•
Use minimum 75°C copper conductors only.
•
To make wiring connections to the power supply connector, follow the table
with cable and torque specifications below:
Terminal Block Connector
Wire Size AWG
Torque (Lb.In.)
X1/X100 Phoenix connectors
AWG 30 – 12
5 – 7
X1/X100 Anytek connectors
AWG 24 – 12
3.5
X1/X100 DECA connectors
AWG 24 – 12
7
•
These devices are Class 2 supplied programmable controllers (industrial PCs)
for the use in industrial control equipment and are intended to be (front)
panel mounted (Type 12 and 4x for indoor use only).
Caution:
The enclosure provides a degree of protection of at least IP20, but when installed in an
apparatus, it should meet IP65.
LE BOÎTIER OFFRE UN DEGRÉ DE PROTECTION D'AU MOINS IP20, MAIS
LORSQU'IL EST INSTALLÉ DANS UN APPAREIL, IL DOIT ÊTRE DE CLASSE IP65.
1.5 During Installation
•
The operator panel is designed for stationary installation on a planar surface,
where the following conditions are fulfilled:
–
no high explosive risks
–
no strong magnetic fields
–
no direct sunlight
–
no large, sudden temperature changes
•
Install the operator panel according to the accompanying installation
instructions.
•
Ground the operator panel according to the accompanying installation
instructions.
•
Only qualified personnel may install the operator panel.
•
Separate the high voltage, signal, and supply cables.
•
Make sure that the voltage and polarity of the power source is correct before
connecting the operator panel to the power outlet.
•
Peripheral equipment must be appropriate for the application and location.
Beijer Electronics, MAEN228
6
