14
ULTRAMIZER PRO DSP1424P
+
Whenever you have edited a preset and pressed the PRESET key three times, all previous
settings in this preset are erased and overwritten with the new parameter values. However, if
you wish to keep the original preset, use the jog wheel to select another preset
before
you
press the PRESET key a third time.
2.5MIDI control
Use the MIDI key combination to select the MIDI parameters you wish to adjust. For this purpose press and
keep the IN/OUT and the PRESET keys for about two seconds. All parameters can be edited with the jog
wheel and the IN/OUT key. The MIDI menu includes six pages which you can select by pressing the IN/OUT
key (forwards) and the PRESET key (backwards) several times.
On the first page you can select the MIDI channel. The display reads a small c (= channel). The jog wheel
adjusts a channel from 1 through 16. To switch off the MIDI function simply select the 0 value
(displayed as -).
On the second page you can select MIDI omni mode, i.e. the unit transmits/receives on all 16 MIDI channels.
The display reads O (= omni). Use the jog wheel to activate (1) or deactivate (0) omni mode.
The third page allows for configuring controller commands. On its right-hand side, the display reads a capital
C (= controller). The jog wheel selects one of the following four controller modes:
'LVSOD\
0RGH
0
No controller data is transmitted
1
Controller data is received but not transmitted
2
Controller data is transmitted but not received
3
Controller data is transmitted and received
Tab. 2.2: Controller settings
The fourth page gives you access to the program change setup. The display reads a capital P (= program).
Here, too, four modes can be selected with the jog wheel, as follows:
'LVSOD\
0RGH
0
No program change data are transmitted
1
Program change data are received but not transmitted
2
Program change data are transmitted but not received
3
Program change data are transmitted and received
Tab. 2.3: Program change settings
The fifth page of the MIDI menu shows the store enable flag represented by a capital S in the display. The
value 0 disables the reception of controller #86, and therefore protects the user presets from being modified
via MIDI. Accordingly, the value 1 enables MIDI controller #86 so that you can modify or replace presets with
a remote MIDI device or a sequencer. In this case the actual settings will be stored directly to the location that
corresponds to the controller value.
+
Attention! Since the store enable mode allows you to access memory locations directly via
MIDI, it is possible that stored presets will be replaced or altered if controller #86 messages are
sent on the same MIDI channel. The purpose of this mode is to facilitate MIDI backup and
restore operations without express confirmation at the ULTRAMIZER PRO. It is therefore
recommended to disable (flag = 0) this mode as soon as the intended data transfer has ended.
This is done automatically when you switch off the ULTRAMIZER PRO.
On the sixth page you can access the system exclusive functions. This is indicated by a d (for dump) in the
display. To the left of this d a number is displayed:
d0 means that no SYSEX data will be sent or accepted. d1 will enable the ULTRAMIZER PRO to receive
data. When PRESET is pressed the unit will wait for data, this is shown by flashing dots (LEDs) in the display.
2. OPERATION
All manuals and user guides at all-guides.com
