7
B-CONTROL
DEEJAY
BCD2000
The WDM/MME page:
Fig. 2.2: The WDM/MME window in the BCD2000 control panel
Use the WDM/MME driver if your music software does not support
ASIO (e. g. most software media players).
RECORD SELECT
allows you to select BCD2000 input
IN A
or
IN B
for 2-channel recording.
When you choose IN A, you can determine in the left-hand field
whether the phono or microphone signal will be recorded.
PLAYBACK of this driver type is always stereo (channels 1-2).
For this reason, the MASTER OUT connectors on the rear panel
and the PHONES connector on the front panel always provide
the same music signal.
The MIDI page:
Fig. 2.3: The MIDI window in the BCD2000 control panel
On the MIDI page no parameters can be set. It only informs you
about the various MIDI modes, depending on the
GLOBAL MODE
selected:
In
B-DJ
mode, the buttons are toggle off, i. e. when you release
a button after pressing, the MIDI command is set back to its
original value (like when you release a key on a keyboard).
In
B-DJ
mode, all LEDs can be switched on and off individually
with specific MIDI commands.
In
ADVANCED
mode, all buttons are toggle on, i. e. press =
switch on; press again = switch off the MIDI function (similar
to a light switch).
In
ADVANCED
mode, the response of the button LEDs depends
on the respective button, i. e. LED on = function enabled, LED
off = function disabled.
2. INSTALLATION
Downloaded from
