10
AUTOCOM PRO MDX1400
15
The
SC FILTER
switch activates a highpass filter in the sidechain path and thus limits the influence of
low frequencies on the AUTOCOM PROs control processes.
16
The 12-digit
GAIN REDUCTION
meter indicates how effectively the gain is reduced by the compressor,
within a range from 1 to 30 dB.
17
The 12-digit
INPUT/OUTPUT LEVEL
meter informs you depending on the setting of the I/O METER
switch about the current input or output level, within a range from -30 to +18 dB. When the switch is
set to IN (engaged), the meter reads the input level, when it is OUT (not engaged), the output level is
displayed. The meter is referenced to the operating level (-10 dBV or +4 dBu) adjusted with the
OPERATING LEVEL switch.
2.3 Dynamic Enhancer Section
18
Fig. 2.4: Control elements of the dynamic enhancer section
18
The
PROCESS
control sets the available amount of enhancement between Off and 6. Dynamic
enhancement allows you to replenish any high frequencies lost through the compression process for
absolutely natural sounding dynamics control. Enhancement is only added when compression is taking
place.
2.4 Rear Panel Control Elements Of The AUTOCOM PRO
20
19
23
22
26
25
24
21
Fig. 2.5: Control elements of the rear panel
19
SERIAL NUMBER.
Please take the time to fill out and return the warranty card within 14 days from the
date of purchase, so as to be entitled to benefit from our extended warranty. Or use our online
registration option available on the Internet at www.behringer.com.
20
FUSE HOLDER / VOLTAGE SELECTOR
. Please make sure that your local voltage matches the
voltage indicated on the unit, before you attempt to connect and operate the AUTOCOM PRO. Blown
fuses may only be replaced by fuses of the same type and rating.
21
MAINS CONNECTION
. Use the enclosed power cord to connect the unit to the mains. Please also note
the instructions given in the INSTALLATION chapter.
2. CONTROLS
Downloaded from
www.Manualslib.com
manuals search engine
