Behncke EWT 60 TD, Инструкция по установке

Страница: 35 / 108

Article kW
A
mm
B
mm
C
mm
EWT 60-20/30/TD 1,5 370 195 120
EWT 60-20/30/TD 2 370 195 120
EWT 60-20/30/TD 3 370 195 120
EWT 60-25/35/TDS 1,5 425 195 120
EWT 60-25/35/TDS 2 425 195 120
EWT 60-25/35/TDS 3 425 195 120
3.3 Set-up
Set up the electric heat exchanger in frost-proof and dry rooms with non-aggressive
atmophere only. Dripping water might damage the electric heat exchanger.
Ensure easy access for installation and removal purposes.
The following water values are always to be observed for the electric heat ex-
changer.
EWT 60-20/30/25/35
Chloride contents max. up to 500 mg/l
Free chlorine max. up to 1.3 mg/l
pH Value 6,8 – 8,2
EWT TD/TDS
Chloride contents max. up to 3000 mg/l
Free chlorine unlimited
pH Value 6,8 – 8,2
salt contents max. 3,5%
Water throughput min. 1000 l/h
Maximum operational overpressure 300 kPa (3,0 bar)
The risk of combustion exists in the case of a failure of the safety devices.
Overheating of the electric heat exchanger might cause a fire.
Draining of the electric heat exchanger during operation must be prevented. Do not
store any combustible material in the environment.
3.4 Installation
Check the electric heat exchanger before installation for visible damage.
The electric heat exchanger can be installed horizontally above or below water level.
The installation of a flow control as an additional safety device is
recommended .
Set-up/Installation
English
35