background image

1.

Test switch indicates bottom of fixture.

2.

Ensure locating pin goes through slot in LED strip (Figure 10).

3.

Un-snap bottom LED strip and gently snap into middle notch and lower notch (Figure 11).

4.

Un-snap top LED strip and gently snap into lower notch and upper notch (Figure 12).

emergency version 

CEILING

 

SURFACE MOUNTING

:

Fixture is shipped with LED strips positioned for 

wall

 mounting. To improve light distribution 

when mounting on ceiling, 

configure 

unit 

for 

ceiling

 mount

 by re-positioning the LED boards.

Ceiling Mount

Locating Pin

Figure 10

Lower 

Notch 

Bottom

Board

Middle

Notch

Figure 11

Figure 12

Lower 
Notch

Upper
Notch

Top Board

RECESS MOUNT

1.

Follow steps 1 to 11 of standard Installation instructions.

2.

Place the unit lens down into the recess trim plate and secure

properly.

3.

Ensure the recess back box is installed as per national and local

requirements.

4.

Fit recess trim plate into the properly installed recess back box

5.

Turn on AC line voltage supply.

Recess Trim Plate

Back box

Figure 15

T-BAR MOUNTING:

Securing strap Electrical Box

Pre-Mounted

Remove securing 
strap screws

1. Follow steps 1 to 11 of standard Installation instructions.
2. Unscrew the two securing screws and remove securing strap (Figure 15)
3. Place the unit lens down into the T-bar housing and secure re-insert the

securing strap.

4. Screw the mounting strap screws back into place.

5. Mount the unit securely into place.  Do not rely on the suspended ceiling

channel / grid (T-bar) as the only support for the unit.  There are four chain

mounting holes provided on each corner of the top of the housing. Chain

or mounting wire should be secured through these holes and then to a

secure mounting point above the suspended ceiling.

6. Turn on AC line voltage supply.

0 to 10V
Supply

Wall Switch

Open= LED Off
Close=LED On

white-neutral

black-120 to 347 VAC hot

green-ground

battery1

battery2

LED1

LED2

dimming

+

-

circuit

board

Figure 8

ELECTRICAL:

Beghelli U.S.A., 3250 Corporate Way, Miramar, Florida, Tel: (800) 726-4316 Tel: (954) 442-6600 

Отзывы: