Befaco CV Thing, Инструкция по сборке

Страница: 7 / 9

CV Thing v1 - ASSEMBLY GUIDE rev. Aug 2021
CALIBRATION
We will perform now a factory calibration. This procedure need to be done with a very precise
voltage source. We suggest to measure with a three digits multimeter.
In order to get into calibration mode, press the encoder for more than three seconds,this will
get you into general settings menu.
Scroll to credits, when splash screen appears, keep the encoder pressed in order to make
Global calibration option available.
When splash screen disappears, scroll down to access global cal.
We will be entering to a two points calibration screen. You will be prompted to send 2 and 8
volts, so they will be stored and correcting any eventual offset and non linearity in your CV
source.
Make sure your CV source is precise enough!
ENJOY YOUR NEW BEFACO MODULE!
7