Beer Grill AG
Beer Grill GmbH
Allmendstrasse 7
Tel. +41 (0)56 618 7800
Körnerstrasse 14 a
Tel. +49 (0)71 61 659 876
CH
– 5612 Villmergen
Fax +41 (0)56 618 7849
D
– 79539 Lörrach
Fax +49 (0)71 61 659 879
www.beergrill.com
Seite 8
2.7 Procedure by lamp bursting and breakage of glass
The infrared lamps are equipped with a shatter protection. This protection prevents touching
of lamps. In case of lamp bursting (infrared, LED and compact fluorescent lamps) glass
shelves, sneeze screen, front and lateral glasses, proceed immediately as follows:
•
Switch off and close counter.
•
Self-service counter: Avoid guests taking food contaminated with glass splinters.
•
Collect and replace all plates filled with food from guests, who have been nearby when
the incident happened.
•
Take out all food containers of the counter. Dispose food in rubbish bin (not in bin for
leftovers).
•
Take off shatter protection glass of defective lamp and clean it.
•
Clean the device and its environment (counter and floor).
•
Replace broken items.
•
Refit shatter protection glass with bracket.
•
Refill counter.
•
Counter is again ready for operation.
2.8 Glazing / Danker of accident
Beer counters are equipped with one sheet safety glass (ESG).
Incorrect, badly mounted or damaged glass may fall out and cause serious injuries. Be sure
to check all glazing before opening the self-service counter, but also after cleaning the glass
(especially the front- glass) if:
•
The glass is placed properly e.g.: In the lower glass holders in the intended slots (not in
the rack separations, nor the discontinued racks). Both sides in the above designed
mounted holders.
•
The glasses have no damage. The safety glass may crack or burst due to internal ten-
sion, even without contact with the damaged edge.
Damaged edges and corners = Cut risk and insufficient support.
•
The glass holder for damage and upper front holder (customer side) is well fitted. (Upper
part must rest on the upper glass edge). These holders are glued. Loosen holders must
be re-glued by qualified personnel. If the glass holder moves upwards, the upper stop
ridge (arrest) of the front glass may be affected and the glass can fall out by strong
contrast shock.
Damaged glass panels must be replaced immediately, glass holders refitted by qualified
personnel. In a pinch, continue working without the glass panels until the required spare
parts arrive.
i
