EN
22
Setting Up and Connecting the Device
PLEASE NOTE!
•
Only connect the device to a plug socket that is properly installed. The plug socket must
also be readily accessible after connection so that the connection to the mains can quickly
be isolated. The mains voltage must match the technical data of the device.
•
Lay the connecting cable in such a way that it does not become squashed or bent and
does not come into contact with hot surfaces (also applies to the hot surfaces of the
device!).
•
Do not use the device in conjunction with extension cables.
•
Always set up the device with a clear space at the sides (at least 20 cm) and clear space
above it (at least 30 cm) on a
fl
at, solid and heat-resistant surface that is resistant to
splashing.
•
Do not place the device below kitchen wall units or similar cupboards. The rising
steam could cause damage to them!
1. Place the device on the kitchen unit or another dry, clean work surface, following the safety
notices and the notices provided at the beginning of this chapter.
2. Insert the mains plug into a properly installed plug socket that is easily accessible.
Handling and Operation
PLEASE NOTE!
•
Do not pour milk or other liquids into the water tank. Only ever use water to make
coffee!
•
Never over
fi
ll the permanent
fi
lter.
Setting the Time
As soon as the mains plug is plugged into a plug socket, the display lighting turns on and the time
12:00
(
15
) is shown on the display (
3
). The clock has a 24-hour time format.
1. Touch
the
fi
eld
PROG
(
18
).
UHRZEIT (time)
(
14
) appears on the display
.
2. Set the hours by repeatedly pressing the
fi
eld
STD
(hours) (
21
)
. If the
fi
elds are pressed for
an extended period, the fast increment mode is activated.
3. Set the minutes by pressing the
fi
eld
MIN
(
20
)
. If the
fi
elds are pressed for an extended peri-
od, the fast increment mode is activated.
After around 10 seconds,
UHRZEIT (time)
disappears on the display. The time is now set.
The time is saved until a new time is set or the device has been disconnected from the
power supply.
02442_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 22
02442_Inlay_DE-EN-FR-ES-IT_A5_V1.indb 22
06.12.2019 11:35:01
06.12.2019 11:35:01
