USER MANUAL FOR BEEM OUTDOORS, LLC. 20KW
SILENT STANDBY GENERATOR SET
44
open?
● Make sure the battery has 12.4 volts or higher?
● Is the power indicator light on or off?
2
). Measurement verifications:
● Fuel gas pressure flow pressure is too high: Turn the regulator adjustment screw
to adjust the gas line pressure.
● Battery voltage verification: use the volt-meter to test the battery voltage, if the
voltage is 12.6 V or higher, the battery has enough power; If the voltage is below
12.6V, the battery will not turn the starter. Recharge or replace battery.
● Cylinder and plug wire check: Refer to the following photo, the plug gap between
the conductor and plug body should be 3-5mm.
Generator hunting elimination:
After starting the generator, if there is an irregular vibration or the engine seems to
speed up and slow down, the generator may be experiencing “hunting”. This is a
common occurrence until the engine adapts to the i
ncoming fuel mixture. “Hunting” can
cause the electrical frequency to fluctuate >2Hz. In most cases the engine will adjust
itself after a couple of minutes. Except for sensitive, high precision electrical equipment,
“hunting” will not interfere with the electrical output of the generator and its’ output. In
the event high precision electrical equipment is being used, while the generator is
“hunting”, the high precision electrical equipment should be immediately disconnected or
turned off until the genera
tor stops “hunting”.
