Beef Eater 1600 Series, Руководство по сборке и эксплуатации

Страница: 33 / 36

33
TROUBLESHOOTING
NOTES
PROBLEM CAUSE CHECK
Barbecue will not light Ignition system not working Check to see visible spark at starter
probe - if no spark is present when
control knob is turned then the unit may
need to be serviced or replaced. Contact
your BeefEater dealer.
Check that there is a visible flame coming
from the pilot ignition tube.
Check that the pilot ignition tube is not
blocked by spider webs or insect nests.
Turning on gas control too quickly Allow at least 5 seconds for gas to flow
through burner before ignition.
No gas flow Check that valve on gas cylinder is
turned on.
Check that burner ports are free of
obstructions.
Check that all gas injectors are clean and
free of obstructions.
Burners not assembled correctly Check that burners are correctly
positioned in the barbecue frame.
Burner ports or throat blocked Check that the burner ports are not
blocked by spider webs or insect nests.
Clean out as required.
Barbecue lights but goes out soon
after starting Fuel supply turned off Turn on gas valve at cylinder.
Gas cylinder low or empty Replace cylinder and carry out a leak
check.
Kink in gas hose Check that the gas line is not kinked or
twisted.
Wind or breeze affecting operation Ensure that the appliance is located out of
the way of wind.
Burners will not cross light from one
to the other Check that cross light channel is in place.
Check that burner ports are free of
obstructions.
Low flame level or low heat output Burners will not cross light Check you are running on correct gas
Check gas injector size is correct.
TROUBLESHOOTING