BedJet VET-800NA, Руководство пользователя

Страница: 11 / 28

IMPORTANT INSTRUCTIONS: USER OPERATING MANUAL
MODEL SKU: VET ‐ 800NA
Revision 1.0 P a g e | 11
Troubleshooting Cont.
Diagnose & Fix
Issue Possible Causes Action
Remote control will not
operate BedJet

Dead battery in remote

Remote control may need to be
re ‐ paired to your BedJet

Make sure remote control LED lights
up when picked up, if not then
replace battery

Re ‐ pair remote control to BedJet
with instructions on page 7
Remote control commands are
not acknowledged with an
audible beep anymore

Audio alert mute may have been
accidentally turned on

Press Mute button on remote
control to unmute
BedJet keeps shutting off
without a shutoff command
being given or beep; BedJet
power button LED is ON and
ERROR LED is NOT flashing and
BedJet can be restarted
normally

This is normal. Once turned on,
every mode has an automatic
shutoff timer. Please see page 8
for information about auto ‐ shutoff
time limits.

Shutoff Timer can be advanced
within certain limits using TIME +/ ‐
button
BedJet ERROR display LED is
flashing and unit will no longer
operate, BedJet beeps 5 times

The BedJet microprocessor has
discovered a monitoring error
within the system. This does not
always mean your BedJet is
malfunctioning and may occur if
you rapidly change modes or
airflow while at the same time
obstructing inlets or outlets.

Check to make sure air filter is clean
and there are no air inlet or outlet
obstructions.

Unplug BedJet for 30 seconds, run in
cool mode for 2 minutes and then
retry warming mode. If this does not
solve the problem, or if the problem
occurs again, contact BedJet support
and record the number of blinking
flashes from the Error display LED.
BedJet delivered warm air but
then while still in warming
mode is blowing cold air

In addition to real ‐ time
microprocessor control of the
heat, the BedJet contains multiple
mechanical ‐ thermal overheat
switches for your protection. They
are extremely sensitive and may
have disabled the heater unit.
They are self ‐ resetting but remain
open until power is removed and
the unit is allowed to cool off.
They may have been triggered by
inlet or outlet blockages.

Check to make sure air filter is clean
and there are no air inlet or outlet
obstructions.

Unplug BedJet for 30 seconds, run in
cool mode for 2 minutes and then
retry warming mode. If this does not
solve the problem, or if the problem
occurs again, contact BedJet
support.