Beco BHCA 64640 B, Руководство пользователя

Страница: 13 / 242

Cooker Hood / User Manual
13 / EN
5 Setting Up the Device
5.4 Connecting to Chimney
1- Flap Pin Socket
2- Flap Pin
Insert the plastic pin (Figure 10 / area no. 2)
on the pin socket on the motor exhaust (Figure
10 / area no.1). Then bend the flap lightly to
insert the other pin on the flap and insert the
other pin to its socket (Figure 10).
If you are going to use the Ø 120/150 mm
plastic Chimney adapter, connect one end of
the pipe to this adapter, if you are not going
to use it, to the direct output on the product.
Connect the other end of the pipe to your
chimney. Check that these two connections
Hold the cooker hood by its body and place it
on the mounting screws on the wall and tight-
en the screws (Figure 9).
Secure the cooker hood with two 4.8x50
screws to the wall through the mounting hole
on the interior of the appliance (Figure 9).
Ø4,8x50mm
Ok Not Ok
(a) (b)
(Figure 9)
(Figure 11)
(Figure 10)
are tight enough so they will not come out
when the appliance runs on full power. Ensure
that the flaps inside the Chimney work when
tightened with clamp. Connect the Chimney
connection duct outside the adapter (Figure
11/a). If the connection duct is fitted inside
the adapter, suction of air shall not occur as
the Chimney flap that prevents the return of
air will remain closed (Figure 11 / b). The
length of the pipe connection as well as the
number of elbows must be as minimum as
possible.
A : Chimney exit pipe
B : Chimney Clamps
C: Plastic Chimney
The valves are closed then the appliance is
not operating and prevent possible outside
odour and dust from entering inside.