Beckhoff CX8093, Документация

Страница: 62 / 73

Error handling and diagosis
CX8093 62 Version: 1.6
LED PN * PROFINET Status Meaning
green red
No name 200 ms flashing off no PROFINET name
No IP 1 sec off, 200 ms on off No IP address
Run on off OK
LED DIAG * PROFINET diagnosis Meaning
green red
Flashing, PN controller
identification 500 ms 500 ms The PN controller is
transmitting an
identification signal
No AR established off 200 ms flashing The establishment of a
connection with the
controller has not been
completed
Device is in IO exchange
Error display of Outputs
CR is set to module
differences 1 s off 200, ms on off Problem with
establishment of a
connection or nominal and
actual configuration differ
Device is in IO exchange
but provider is in stop 200 ms off Coupler is in data
exchange, but PLC is in
stop
Device is in IO exchange on off OK
* ) If a virtual PROFINET device has been projected, this is also signalled by the LEDs in the event of an
error. The real device always has the higher priority; if it is OK the status of the virtual device is displayed.
LED power supply terminal
Operation with E-bus terminals Operation with K-bus terminals
Display LED Description Meaning
1 Us 24 V (top left, 1st row) CX80xx supply voltage connected to -24 V
2 Up 24 V (top right, 1st row) Power contacts supply voltage connected to -24 V
3 L/A (left centre, 2nd row) EtherCAT LED flashing green: EtherCAT
communication active
connected to E-bus / no data traffic
not connected to E-bus
4 K-BUS RUN (right centre, 2nd
row) K-bus LED RUN Lights up green: K-bus running,
everything OK
6 K-BUS ERR (bottom right, 3rd
row) K-bus LED ERR Lights up red: K-bus error - see K-
bus error code