Beckhoff CPX29 0000 Series, Инструкция по установке и эксплуатации

Страница: 24 / 39

Mounting and wiring
CPX29xx-0000 24 Version: 0.2
5.2.2 Fitting the power supply cable
Conductive cross-section
The connector is specified for 10 A and can lift conductive cross-sections until 1.5 mm
2
.
Fit the cables for the power supply of the Control Panel, using the included material for assembling the
connectors:
Material for assembling the
connector
Plug connector 5-pole Stain relief housing with lacing cord
So the connector is fitted to the cable
1. Strip insulation from the cable ends (Length of stripped conductor is 8 - 9 mm).
2. Screw together the cable ends in the 5-pole plug connector in accordance with wiring diagram.
Applying the strain relief
Thread the lacing cord into that lower part of the stain relief
housing.
Putting in the plug connector
Put the plug connector into that lower part of the stain relief
housing.
Tighten the lacing cord and pinch off the plastic strap.
Fixing the upper part of the stain relief housing
Fix the upper part of the stain relief housing by snapping it
onto the lower part.