12
Assembly and Operating Instructions
Retrofitting and operation of radio control system
Door control unit
S80
with MLS Professional Card can be pro-
vided with a 1-channel or 4-channel radio remote control system.
If such a system has been ordered with the control unit, the radio
receiver will already have been installed in the control unit. If this
is the case, please proceed to the section “Operation”.
Note
The radio control system cannot be used in con-
junction with the MLS Basic Card. It will not oper-
ate.
If a radio remote control system is being retrofitted, you must first
install the receiver board on the motherboard. For this disconnect
the entire door control system from the mains.
Insert the radio control receiver board in slot
J1
at the top right of the
S80
motherboard, as shown on the drawing. Make sure
the board is the right way round.
Operation
1-channel radio remote control
The 1-channel radio remote control operates in the same way as the 1-way pushbutton switch. The pushbutton commands
are executed one after the other in the sequence UP - STOP - DOWN - STOP. If there is a fault, the pushbutton commands are
executed one after the other in the sequence UP - STOP - UP.
4-channel radio remote control
The 4-channel radio remote control has the following functions:
Button 1: As with the 1-channel pushbutton switch the pushbutton commands are executed one after the other in the se-
quence UP - STOP - DOWN - STOP. If there is a fault, the pushbutton commands are executed one after the other
in the sequence UP - STOP - UP.
Button 2: Operation identical to that of
UP
button.
Button 3: Operation identical to that of
DOWN
button. In the event of a fault this button is activated in the dead-man mode.
Button 4: Operation identical to that of
STOP
button.
Caution
When using a radio control system the person controlling the door must have a clear view of the door and
its surrounding area during door movement and must not be in a dangerous position.
In setting mode and in the event of a malfunction, the radio receiver board must be removed from the PCB
slot J1.
Programming the Hand-held Transmitter Code
The hand-held radio control transmitter has been coded by the manufacturer. The radio control receiver must be set to this
code. To program the hand-held transmitter code in the radio control receiver proceed as follows:
• Press Program
Channel 1
on the radio control receiver. The relevant red signal LED begins flashing. You can program the
hand-held transmitter code within the next 15 s.
• To do this press the button on the hand-held transmitter for approx. 2 s. The programming of the hand-held transmitter
code is confirmed by the signal LED on the receiver staying on continuously.
• Now let go of the button on the hand-held transmitter.
You can program the other 3 buttons on the four-channel receiver in the same way. All in all you can program up to 60 differ-
ent transmitter codes (buttons) for each receiver. The 61st code will not be accepted by the receiver. In conjunction with the
1-channel receiver you can therefore use up to 60 1-channel hand-held transmitters and in conjunction with the 4-channel
receiver you can use up to 15 4-channel hand-held receivers (if all the buttons are used).
Note
You can combine all hand-held transmitters with all receivers.
Example:
You have an application with 4 doors each of which is controlled by an S80 with 1-channel radio control
receiver. If you use 4-channel hand-held transmitters and assign each button to one of the 4 receivers,
you can control all 4 doors independently of one another with just one hand-held transmitter. If you re-
quire more than 60 transmitter codes, please contact us. Here too we can offer customised solutions.
J1 FUNK
receiver board
Содержание S80
Страница 20: ...4023 630 822 0c 02 13 ...
