Becker Avionics
Installation
Configuration-Setup
DV17551.03 Issue 03 June 2020
RCU6512
35
2.8.1.4 RCU - Memory
Display Contents
Setting of RCU parameters
Figure 16: "CU MEMORY"
•
The display shows "CU MEMORY".
With "STORE CHN_ON" the store function of memory channels will
be enabled.
•
Use "STO" key to select/deselect check box.
•
Push rotary encoder push button.
Figure 17: "CU ERASE_MEM"
•
The display shows "CU ERASE_MEM".
To erase memory channels:
•
Select "YES" with the rotary encoder
•
Push "STO" key to accept selection.
Figure 18: "Memory Erased"
•
The display shows "MEM ERASED".
Notice:
Only one memory bank, the memory channels for current selected
channel spacing is erased.
To erase the second memory bank, change the channel spacing and
repeat the erase procedure.
* For details please refer to: "Start Configuration Mode" page 37
→
Channel Spacing.
2.8.1.5 RT - Parameters
Display Contents
Setting of RT6512 parameters
Notice:
The change of RT6512 installation parameters is only possible when
installation switch* ("INS_SW") is closed.
* For details see wiring "Figure 9: RT6512 with RCU6512 as Primary Controller",
2.8.1.6 RT - Volume, Squelch, Sidetone
Display Contents
Setting of RT6512 parameters
Figure 19: "RT CONFIG"
•
Push rotary encoder push button.
•
The display shows "RT CONFIG".
Select/deselect check boxes to set the function allowed or blocked.
•
Use rotary encoder to navigate between the functions.
o
Use "STO" key to select/deselect check boxes.
•
Push "STO" key to accept selection.
