Becker P5-B01, Руководство по сборке и эксплуатации, Страница: 11 / 20

After programming the transmitter, position the barrel so that the roller shutter curtain can be mounted with springs or fit the anti-
lifting device in accordance with the manufacturer's instructions.
When using springs/anti-lifting devices, we recommend you use at least three; for longer tubes, use three
springs/anti-lifting devices per meter of barrel.
Lay the connecting cable
Lay the connecting cable up to the tubular drive, and fix The connecting cable and
any antennae must not project into the winding chamber. Cover any sharp edges.
Preparation for Commissioning
The tubular drive can be operated with any suitable KNX transmitter
The commissioning (e.g. setting the limit positions etc.) and later configurations are, however, only possible with a B-Tronic trans-
mitter.
The running direction must be correct. When setting the limit positions, the tubular drive runs with the limit po-
sition status indicator. The upper limit position must always be set first. When setting the upper limit position,
ensure that the roller shutter curtain is not pulled out of the guide tracks.
When first installing, using springs and adjusting the limit position ‘...to lower stop’, the barrel in the lower limit
position turns approx. 1/4 of a turn further than usual. In doing so, the tubular drive is able to detect the use of
anti-lifting devices or springs automatically. The tubular drive switches off automatically.
Limit position status indicator
A brief stopping and restarting indicates that no limit position has been set in that direction of movement.
Completion of installation following automatic setting of limit positions
The drive saves the limit position permanently once the upper limit position is reached 3 times in succession. Installation is then
complete. If the limit position is set above a point, this is stored permanently.
Explanation of symbols
1 = direction switch
2 = radio switch
N
1
2
1
2
4
3
4
230V AC / 50 Hz
L1
PE
Connecting the tubular drive
Connect the tubular drive to the power supply.
1 = blue 3 = black
2 = brown 4 = green-yellow
If several tubular drives are to be connected in parallel, you can deactivate the programming mode on one tu-
bular drive by switching the radio switch to the outside position after turning the power on. If the radio switch is
already in this position, switch it to the inside and back to the outside position.
11