Becker HPP-SB, Инструкция по эксплуатации

Страница: 18 / 26

Parts Ordering
The following is provided to allow the ordering of replacement parts. Please specify the Becker
valve regulator serial number when ordering parts (this can be found on the
Stainless Steel attached to the positioner by on of the 7/16 hex head cap screws.
Drawing #35-0501
HPP-SB Positioner
Parts
HPP-SB 18 September 1999
Key Description Part No.
1 Spring Cartridge 25-1094
2 Top Inside Piston 35-1528
3 ¼-20 x ¾” HHCS S.S. 98-3137
4 Bottom Inside Piston 35-1529
5 Outside Piston 35-1506
6 Beam Adjustment Drum 25-1124
7 ¼ NPT Vent Elbow 01-2572
8 Lexan Cover 25-1034
9 Seat Cover 35-1519
10 10-32 x 3/8” FHMS S.S. 98-2684
11 ¼-20 x 1” SHCS S.S. 98-3149
12 Spring Nut 25-1076
13 Washer 25-1016
14 Single Top Body 35-1536
15 Sensitivity Spacer 25-1015
16 ¼-20 x ½” S.S.S. 98-2761
17 O-Ring –010 95-2609
18 Balance Valve Assembly 35-1510
19 Single Bottom Body 35-1537
20 Seat Cover 35-1526
21 ½-20 Hex Nut S.S. 98-3056
Key Description Part No.
22 Beam Spacer 25-1081
23 0-30 Pressure Cartridge 25-1082
24 Diaphragm 25-1213
25 Spring Retainer 25-1123
26 Spring 25-1217
27 Beam Block 25-1086
28 Pivoted Beam 25-1084
29 1/8 Roll Pin 98-2950
30 8-32 x 1” SHCS S.S. 98-3144
31 Seat Assembly 01-7082
32 ½-20 Aluminum Nut 25-1065
33 Thrust Bearing 25-1062
34 Adjusting Drum 35-1534
35 O-Ring -012 95-2615
36 Pilot Post 35-1535
37 8-32 x ½ SHCS 98-2614
38 Diaphragm w/ Convolute 25-1027
39 ¼ NPT S.S ST. Elbow 94-2511
40 Strainer for B.V. 35-1559
41 S.S. Control Tag 25-1060
Seal Kit
A seal kit containing diaphragms, o-rings,
seats, and balance valve assemblies for the
HPP-SB positioner is available directly from
Becker. Simply contact Becker Precision
Equipment and refer to the following part num-
ber: