Becker Centronic UnitControl UC520, Руководство по сборке и эксплуатации

Страница: 34 / 76

Programming
Programming the daily run times
To program the desired UP run time, press the UP button for at least
6 seconds. The indicator lamp will then flash briefly three times. This drive
command will now be repeated every 24 hours.
To program the desired DOWN run time, press the DOWN button for at least
6 seconds. The indicator lamp will then flash briefly three times. This drive
command will now be repeated every 24 hours.
Overwriting the run times is possible at any time. Repeat the
programming phase to set the new desired daily run time.
Deleting the daily run times
To delete the UP and DOWN run times, press the reset button
All the run times, intermediate positions and tilt positions/
ventilation slots can be deleted by pressing the reset button
(with a ballpoint pen or similar object).
Intermediate position I
The intermediate position I is any shading solution position of
your choosing, situated between the upper and lower limit
positions. Both limit positions must be set before the inter-
mediate position I is set.
The intermediate position I is approached from the upper
limit position.
Setting the intermediate position I
Requirement: The shading solution is in the upper limit position.
1.
Press the intermediate position I programming button and keep it
pressed.
2. Also press the DOWN button until you have reached the desired interme-
diate position I. You can make a correction with the UP button or the
DOWN button.
3. Release the intermediate position I programming button . The indicator
lamp will then flash briefly three times.
The intermediate position I is now saved.
34 - en