Device Configuration
Interface Setup
– Internet (EWAN)
52
BEC MX-200 User Manual
IP Options
IP Common Options
Default Route:
Select
Yes
to use this interface as default route interface.
TCP MTU Option:
Enter the maximum packet that can be transmitted. Default MTU
0
means it is set
to 1492 bytes.
IPv4 Options
Get IP Address:
Choose Static or Dynamic
Static IP Address:
If
Static
is selected in the above field, please enter the specific IP address you get
from ISP and the following IP subnet mask and gateway address.
IP Subnet Mask:
The default is 0.0.0.0. User can change it to other such as 255.255.255.0.Type the
subnet mask assigned to you by your ISP (if given).
Gateway:
Enter the specific gateway IP address you get from ISP.
NAT:
Enable to allow MX-1000 to assign private network IPs to all devices in the network for get
Internet access.
Dynamic Route:
RIP Version:
(Routing Information protocol) Select this option to specify the RIP version,
including RIP-1, RIP-2.
RIP Direction:
Select this option to specify the RIP direction.
-
None
is for disabling the RIP function.
-
Both
means the router will periodically send routing information and accept routing
information then incorporate into routing table.
-
IN only
means the router will only accept but will not send RIP packet.
