BeBionic bebionic3, Техническая информация

Страница: 61 / 68

61
IMPORTANT NOTE:
In the event that these conditions can not be met (for certain configurations or co-location
with another transmitter), then Industry Canada certification is no longer considered
valid and the IC Certification Number can not be used on the final product. In these
circumstances, the OEM integrator will be responsible for re-evaluating the end product
(including the transmitter) and obtaining a separate Industry Canada authorization.
End Product Labeling
The AMB2520-RSL Module is labeled with its own IC Certification Number. If the IC
Certification Number is not visible when the module is installed inside another device,
then the outside of the device into which the module is installed must also display a label
referring to the enclosed module. In that case, the final end product must be labeled in a
visible area with the following:
“Contains Transmitter Module IC 10634A-RSLRFBB”
or
“Contains IC 10634A-RSLRFBB”
The OEM of the AMB2520-RSL Module must only use the approved antenna(s) listed
above, which have been certified with this module.
The OEM integrator has to be aware not to provide information to the end user regarding
how to install or remove this RF module or change RF related parameters in the user’s
manual of the end product.
The user’s manual for the end product must include the following information in a prominent
location:
“To comply with Industry Canada RF radiation exposure limits for general population,
the antenna(s) used for this transmitter must be installed such that a minimum
separation distance of 20cm is maintained between the radiator (antenna) and all
persons at all times and must not be co-located or operating in conjunction with
any other antenna or transmitter.”