11
10
Assembly / Operating Instructions
Restraints - Harness
1. To secure the child in the harness, place left
hand buckle prong (b) on top of (a).
2. Hold both left hand buckle prongs (a) and (b)
together and insert it into buckle housing (e)
until it snaps into position.
3. Repeat previous steps for right hand buckle
prongs (c) and (d).
4. Once all attached, carefully adjust the harness
straps by pulling each slider (f) until the desired
fit is achieved in the lap, shoulder and crotch
straps.
5. To release the buckles, squeeze the top and
bottom prongs (a) and (b), (c) and (d) together
until harness disengages.
CAUTION:
Always adjust the harness when
changing the seating position of the child.
(a), (b): Left hand buckle prongs
(c), (d): Right hand buckle prongs
(e): Buckle housing
(f): Strap adjustment sliders
f
f
f
f
f
a
b
c
d
e
Top strap
Bottom
strap
To adjust waist strap
1. To loosen waist strap, push up both top and
bottom straps through buckle as circled in
diagram.
2. To place waist strap in desired position, slide
the bottom strap into position then pull the top
strap and tighten into position.
WARNING:
Use this harness at all times.
Car Seat Adapter
1.
Remove the seat from the frame of
the stroller. Insert the set of plastic
adapters into the slots where the seat
normally sits in position. Push gently
until the adapters ‘click’ and lock
into place. The left adapter should
be placed on the left when facing the
stroller from the front, and the right
adapter on the right when facing the
stroller from the front.
This adaptor is designed for Maxi Cosi Car Seat; to be used with the
following strollers:
bebe care Rverse / Rverse XT / Rverse XLR / Childcare Vogue
IMPORTANT:
Insert car seat into adaptor
1.
Insert the Maxi Cosi car seat as per car seat manufacturer’s
instructions by aligning the plastic side parts of the car seat into
the corresponding adaptor.
2.
Push the car seat down until it clicks into place.
3.
Swing the car seat’s handle down while pressing both grey
levers on the car seat side handle moulds until it locks into
position.
4.
Car seat can be attached to stroller frame in either forward
facing or reverse facing.
5.
To rotate car seat in opposite direction; rotate the car seat
together with the adaptors and insert them into the side stroller
frame’s slots until it ‘clicks’ and locks into place.
WARNING: Lift the Maxi Cosi Car Seat upwards to ensure that it
is fully engaged and locked before use.
Assembly / Operating Instructions
