Firewall
90mm
(3.54”)
B’
B
B=B’
A
A=A’
A’
! Engine thrust on balk head
is already adjust at factory
-Attach the aluminum motor mounting
plate on to the motor and secure it in
place with four screws ( included with
motor set) (7).
-Push the four 5x35mm bolts through the fire-wall as shown (5).
- Reposition the plywood motor mounting plate (2pcs) and secure
it in place with twelve 5xmm nuts and washers (6).
Note: B=B’(Side-view) and A=A’(Top-view)
2- Motor mount / Motoreinbau
FRONT-VIEW
- Using a plywood motor mounting plate as a template, mark
the fire wall where the four holes are to be drilled (1).
5mm
13/64”
! Align the mark on the plywood motor
mount with the mark on the fuselage.
! Align the mark on the plywood motor mount
with the center lines on aluminum motor mount.
- Remove the plywood motor mounting plate and drill a 13/64”(5mm) hole through the fire-wall at each of the four marks
marked (2).
- Using a aluminum motor mounting plate as a template, mark the plywood motor mounting plate where the four holes are
to be drilled (3).
- Remove the aluminum motor mounting plate and drill a 1/8”(3mm) hole through the plywood at each of the four marks
marked (4).
3mm
1/8”
1
2
3
4
Plywood motor
mounting plate (2pcs)
Aluminum motor
mounting plate
5
6
7
Motorspant
TOP-VIEW /
Draufsicht
SIDE-VIEW /
Seitenansicht
Sturz und Zug beachten!
Sperrholztrager Platten zusammenkleben, wie gezeigt ausrichten
und Locher bohren.
Motor nach untenstehendem Schema einbauen.
Fur optimale Leistung empfehlen wir folgende Komponenten:
-Brushless-Motor PICHLER BOOST 60
-Brushless Regler PICHLER XQ-70
-LiPO Akku LEMONRC 3700-5S
-Luftschraube 12*6 - 13*8
For maximum performance, we recommended
the following:
-Brushless-Motor PICHLER BOOST 60
-Brushless Regler PICHLER XQ-70
-LiPO Battery LEMONRC 3700-5S
-Propeller 12*6 - 13*8
3- Electric Motor /
X4
X16
X12
5x35 screw
5mm washer
5mm nut
