beau lake The Newport 11, Руководство пользователя

Страница: 7 / 19

9 10
LEASH
The Beau Lake SUP Leash is designed to keep The Newport
comfortably close to you in all paddleboard conditions.
Features
• 11’ / 3.35 m length
• Neoprene adjustable and padded Ankle Cuff
with Velcro close and tangle-free swivel
• Velcro board attachment strap with tangle-free swivel
REPAIR KIT
Your “just in case” premium Repair Kit includes:
• Spare Fin Screw & Nut
• 2 x Navy Rail Patches
• 2 x White Deck Patches
• 1 x Repair Adhesive
INFLATING THE NEWPORT
Follow these steps to get The Newport correctly inflated
and ready for action.
Getting Ready to Pump
1. Take the deflated paddleboard out of your iSUP Travel Bag
and unroll it on a flat surface, top-side up.
2. Screw the wider end of the flexible pump hose
to the receptacle on the pump's handle.
3. Turn and release the valve cap near the tail of the board.
4. Push and turn the yellow fill valve 90 degrees clockwise
so it springs up.
5 . Attach the valve end of the flexible pump hose to the valve
by pushing down and turning clockwise.
Pumping
1. Flip the lever on the back of the pump to the left to engage
the high-volume setting. This allows for faster initial inflating
because air is pumped into the board with each down stroke
and up stroke.
2. Place your feet firmly on the pump's foot pegs
and begin pumping.
3. Once the gauge registers around 12 PSI, you may want to flip
the lever to the right to engage the high-pressure single-action
mode. Here, air will be pumped on the downstroke only making
it easier to pump.
4. For everyday paddling, an internal pressure
of 15 PSI / 103.4 kPa will be sufficient for most riders.
However, the premium fabrication techniques used
in the construction of The Newport allow this iSUP
to achieve an industry-leading pressure rating of 20 PSI,
which is recommended to all paddlers for heightened
stability and responsiveness on the water.
5. Once fully inflated, remove the hose and twist
the valve cap back into place.
Attaching the Fin
1. Flip the board over to bottom-side up.
2. The black fin housing mount is at the tail of the board.
The fin slides into the lengthwise grooves that run fore
and aft of the housing.
3. Unscrew the silver nut from the screw attached to the fin,
then place the nut into the housing groove and slide it towards
the front end (facing the board's nose) of the housing mount.