Beastx MICROBEAST PLUS, Руководство пользователя, Страница: 147 / 353

62 Adjustment on the device
62.1 Separate servo trim
Initially the trimming is 0 for all servos. In this case the Status LED will be off when
entering Setup Menu Point J. At first, attach the servo horns to the servos in this position.
So you will make sure to get roughly equal throws to both directions. Mount the servo
horns so that they form a 90 degrees angle to the linkage rod as close as possible. Then in
the next step you can fine trim every single servo‘s center position, as usually mounting
the servo horns at exact 90 degrees will not work out perfectly, depending on the servo
gear trains and the servo horns.
By tapping the rudder stick you can select one servo after another . Every color of the
Status-LED is corresponding to a specific servo channel that is indicating its selection by a
short up and down move. Use the
aileron stick to change the servo trimming/adjust
the center position . You can switch back and forth between the servos with rudder as
often as you need.
Status-LED Servo trim
off all zero
purple CH1 – elevator servo
red CH2 – aileron(1) servo
blue CH3 – aileron(2) / pitch servo (mCCPM)
red/blue CH7 – elevator servo(2) (90° eCCPM only)
62.2 Trimming the swashplate
If necessary, you can also trim the swashplate position at once. For this push and hold the
button for at least 2 seconds when at Setup Menu Point H, then release. Now you can trim
139