Beast RS34, Руководство по эксплуатации

Страница: 13 / 16

®
RS34 - RS48 - RS59
BEAST BRIDGE SAWS OPERATING MANUAL
13
Troubleshooting
The machine does
not work.
- The power supply cable is
damaged or not properly
connected.
- No voltage in the power outlet.
- Start Switch is damaged.
- Press the plug firmly in the power
outlet. Check the power supply
cable.
- Have the power outlet checked.
- Have the Switch replaced.
Water does not
flow at the blade
while the pump is
running.
- The sprayers are clogged.
- The water level in the waterbin
is not sufficient. The pump is not
totally submerged.
- Water valve is closed.
- Clean the sprayers
- Fill the waterbin with clean water
until the pump is totally submerged.
- Open the valve.
Motor is not running
properly.
- Water may have seeped through
inside the motor.
- Capacitor is damaged.
- Motor bearing are damaged.
- Unplug the power cable and
consult your local dealer.
- Unplug the power cable and
consult your local dealer.
- Unplug the power cable and
consult your local dealer.
Pump is not
running.
- The impeller or suction filter of the
pump is damaged.
- No proper connection of the
power cable.
- Replace damaged parts.
- Have the connection checked.
Bad cutting
alignment.
- Machine is not level.
- Unlevel working surface.
- Improper or glazed diamond
blade.
- Loosen the screws for the legs.
Pick up the machine a little bit on
one end. Let the machine down
again and tighten screws. Do the
same procedure for the other end.
Machine should now be level.
- Make sure the machine is placed
on a level surface.
- Replace or dress the diamond
blade.