Beast RS34, Руководство по эксплуатации

Страница: 12 / 16

®
RS34 - RS48 - RS59
12
BEAST BRIDGE SAWS OPERATING MANUAL
MAINTENANCE & TROUBLE-
SHOOTING
General Maintenance
• The cooling water should be replaced
and/or replenished regularly.
• It is recommended to clean the water
container, pump, hoses and spray noz-
zle on a regular basis. For example,
place the pump in a bucket of clean
water after the sawing job and run the
machine for a minute or so. This also
guarantees a longer lifetime of the
pump.
• When the machine is not used for a
longer period, the pump should not
remain in the muddy cooling water.
Cleaning the pump as described
above and leaving it outside the water
container is recommended.
• Regularly check the saw flanges for
wearing out and replace if necessary.
Diamond blade dressing
Diamond blades performs best when they
are dressed. After time and use, diamonds
on the outer edge of the blade might beco-
me glazed or dull.
This will reduce cutting efficiency and
possibly cause the blade to bend.As a
result the cut will not be straight and mis-
aligned.
When this occurs, the blade needs to
be dressed. The diamond blade can be
dressed with a Dressing Stick.
Dressing procedure(s):
• Place a Dressing Stick on the saw
table.
• Make approx. 10 cuts through the
Dressing Stick.
The diamond blade should be sharp again
and ready for efficient cutting.