Beam IntelliDOCK 9555, Инструкция по установке и эксплуатации

Страница: 12 / 22

IntelliDOCK 9555 Installation & User Manual
22 23
Privacy Handset (optional accessory)
The IntelliDOCK provides a 4-pole 3.5mm audio socket on the rear cable
loom, for connection to the Beam Privacy Handset. This provides local
handset function, conveniently mounted next to the IntelliDOCK cradle.
1. The Privacy Handset Kit (purchased/ordered separately) contains
a mounting bracket, space plate, and fasteners.
2. Mount the handset cup to the mounting plate.
3. Mount the spacer plate and the mounting bracket to the rear of the
IntelliDOCK, by using the longer screws provided with the kit. The
original RAM arm-bracket plate is also re-installed behind these
plates.
4. Plug the Privacy Handset 4-pole connector into the rear
cable loom. (Please use suitable electrical tape and/or strain relief
clamps where required to ensure reliable connection)
Privacy Handset mode is enabled when the handset is removed from
the cup. Please ensure to re-dock the Privacy Handset when not in use.
Preliminary Testing
Prepare the Iridium 9555 Handset
1. Ensure that the 9555 Handset is running with the required
compatible firmware.
2. Remove the rubber plug / bung / grommet from the rear of the 9555
Handset, to reveal the antenna socket hole.
Connect Power
Once all the components are installed, apply appropriate fuses, and
apply power to the cradle.
1. After a few seconds the cradle LEDs will start to operate.
2. Once the cradle appears to be powering okay, dock the 9555
Handset (refer to section: “Docking & undocking your 9555
handset” )
3. Please wait for the Handset to automatically power cycle and then
progress to find registration.
Bluetooth® Configuration (optional)
IntelliDOCK has an in-built Bluetooth® module for voice and data con-
nectivity. The Factory Default power mode is Class 2 (> 10 metres) low
power. If you require Class 1 (>100 metres) high power, this can be
selected in the PDMS settings.
Bluetooth® Headset Configuration
To configure (pair) to a Bluetooth® headset (audio) device:
1. Power up the IntelliDOCK system, to ready state.
2. Discovery Mode:
Press and hold for 5 secs the Bluetooth®
button on the cradle, until the cradle sounds a double (2)
beeps. The LED will then flash BLUE and ORANGE until the audio
device is paired.
3. Hold the Headset (device) button(s) to enter pairing mode (please
refer to the headset user instructions)
4. Once the devices are successfully paired, the Bluetooth® LED on
the cradle will change to BLUE (half intensity).
5. Bluetooth® can be turned ON with a single press , and OFF by
press and hold for 2 secs the Bluetooth® button on the
cradle. The cradle will sound a single (1) beep when turning off.
Once paired, the IntelliDOCK will automatically connect to this device
every time the IntelliDOCK powers up.
You may repeat this process to pair more than one headset (up to 17
total devices including data) – ensure only one device is switched on
during subsequent paring configuration.
NOTE:
To clear all paired devices from IntelliDOCK memory, Press and
hold for 10 secs the Bluetooth® button on the cradle, until the
cradle sounds a triple (3) beeps.