Beam IntelliDOCK 9555, Инструкция по установке и эксплуатации

Страница: 10 / 22

IntelliDOCK 9555 Installation & User Manual
18 19
B: Powering from the “DC power cable / lead”
The DC power cable / lead can be used where AC power is unavail-
able. This can be connected to a 9 to 32V DC power source (such as
a vehicle battery).
1. Route the power cable from the IntelliDOCK cradle to the connec-
tion point, DO NOT apply power until complete.
2. Prepare the fuse block. Remove all fuses, and tape them to their
respective holders, before making any connection. DO NOT insert
fuses until you have completed and inspected all connections.
3. Connect the BLACK Ground wire to negative battery / vehicle
chassis (if negatively grounded chassis).
4. Connect the RED +VIN wire to the v Battery via a 3A fuse.
5. Connect the YELLOW Accessory wire to the vehicle accessory
power, via a 1A fuse. (This may be connected to Vehicle Ignition
voltage if Accessory power is unavailable). The Accessory (or ON/
Off Sense) enables the IntelliDOCK 9555 to automatically power
on and off as the vehicle key is enabled.
If this function is not required, this
YELLOW Accessory wire MUST
be also connected to the +VIN ( RED wire).
ACC - On/Off Feature (DC cable lead)
The DC Power lead allows users to control the on/off status of the
IntelliDOCK. This input ( YELLOW wire of the DC cable lead) can
be connected to a vehicle’s accessories, ignition or other similar
circuits to allow the user to control the on/off status of the IntelliDOCK in
synchronization with a vehicles operation.
If this function is not required, this
YELLOW wire MUST be connected
to the +VIN ( RED wire).
By default the IntelliDOCK will stay on for 20 minutes after being switched
off by the Accessories. If Accessories is switched off during a call, the
IntelliDOCK will stay on for 20 minutes after the termination of the call.
Wiring for a Marine Application
When installed in a marine application using the DC cable lead, the
YELLOW wire of the DC cable lead can be wired to a suitable panel
switch which will allow the IntelliDOCK 9555 to be turned on and off
when not in use or to dock or undock the 9555 handset.
Installation Procedure
Installing the IntelliDOCK Cradle
Install the components in the following order:
1. Mount/Install IntelliDOCK cradle
2. Install External Iridium Antenna (ordered
as extra option)
3. Install Privacy Handset (ordered as extra
option)
4. Connect Power
5.
Configure Bluetooth® (optional)
When selecting a location for the IntelliDOCK cradle, consider these
guidelines:
◊ Ensure that each mounting surface is strong enough to support the
control unit.
◊ Allow enough room so that you can easily insert the 9555 handset
into and remove it from the cradle.
◊ Ensure that the IntelliDOCK is within cable distance of power and
antenna connections
◊ Position the handset and cables so that it does not interfere with
vehicle operation or with driver or passenger seating or leg space.
◊ Ensure sufficient room is allowed for the antenna and interface
cables to be routed from the rear of the IntelliDOCK.