FOR SERVICE: 1-866-850-6662 & WWW.BEPRESSURE.COM
10
11
FOR SERVICE: 1-866-850-6662 & WWW.BEPRESSURE.COM
WINTERIZING YOUR UNIT
WINTERIZING YOUR PRESSURE WASHER
Whenever your machine will be subjected to freezing temperatures, severe
damage could occur caused by freezing inside components. To prevent
costly repairs, follow the steps below (Freeze damage is NOT covered by
manufacturers warranty).
Obtain one-gallon container of nontoxic
(RV) antifreeze.
5
To reuse pressure washer, simply reconnect to pressure system water supply, attach high pres-
sure hose, turn water on and squeeze trigger allowing water to pass through system (do not start
engine). Once water becomes clear, you are ready to operate your pressure washer.
Disconnect your high pressure hose, gun, and wand. Attach a 4 ft piece of garden hose to the
inlet of the pressure washer. Using a funnel, fill the garden hose with RV antifreeze and hold in
the air above the pressure washer. Turn the engine ON/OFF switch to the “OFF/STOP” position.
Pull the start cord until the antifreeze is coming out the high pressure quick connect coupler (Ap-
proximately 5-20 times). Disconnect the 4 ft piece of hose.
3
2
1
Be sure the Machine is OFF, water supply
is disconnected and pressure has been
relieved.
If possible, store the gun, wand, and hose indoors where they won’t freeze. Ensure any leftover
water has been drained from the gun, wand and hose. Gas in the engine should be drained or use
a fuel stabalizer to prevent the fuel from going bad. When refilling the unit later, make sure to
use fresh gas and not gas that has sat over winter.
4
Make sure the engine is turned off after each use. It should not be left running without use for
longer than 2 minutes as the pump can overheat.
9
10
7
8
5
Check the choke and throttle levers.
6
2
1
Hold the gun trigger open while pull
starting the engine.
Check for O-Rings in the lance and quick
couplers.
Only the black nozzle is for soaping at
low pressure.
Is the water inlet screen clogged?
Is the correct nozzle in the lance? Is the
nozzle plugged?
If a 5HP, 6.5HP, or 13HP unit has a
sight glass, the pump oil will need to
be replaced.The oil for the pump is a
30W non-detergent mineral oil.
Is the water tap open?
Prior to boxing and shipping, your unit has been tested to ensure quality.
As a result, trace amounts of gasoline may be present. The engine and
pump are also filled to the required levels.
Check oil and gas levels on the
engine.
Are the engine and fuel switches in
the “ON” position?
Do not
fill over
halfway on the
sight glass.
4
3
11
TROUBLESHOOTING
