Be Modern 800CF, Инструкция пользователя

Страница: 30 / 56

30
4.2 Connecting the Appliance to the Gas Supply
The gas supply should be connected to the appliance by a concealed fitting from the rear. In
all installation conditions the gas connection should be provided using 8mm (O/D) copper
tubing.
No soldered joints should be used with the firebox of the appliance. The blind
grommet which is supplied in the standard fitting pack MUST be used to close up the knock
out hole—simply cut a small cross with a sharp knife in the centre of the grommet—this will
then seal around the gas pipe to provide a tight seal.
Under no circumstances should this gas
entry hole be left open and unsealed as this can result in flame reversal and can cause
damage to the appliance. Should this occur the warranty to this appliance will be rendered
void.
Before connecting the gas supply to the appliance the supply should be purged to ensure no
debris can enter the appliance and a gas soundness test should be performed to ensure that
the existing pipe work in the property is sound.
The following diagrams show the access to the inlet gas pipe where the isolation valve will be
fitted.
If the burner tray needs to be removed, see full details on pages 42 - 44.
The gas connection should be made to the appliance by the 8mm restrictor isolation valve
supplied with the appliance. This restrictor elbow is supplied loose and should be fitted as
per the label on the instruction packet.
Test the operating pressure of the appliance by attaching a pressure gauge to the test point
of the appliance. This connection should take place when the appliance is OFF. Ensure that
gas is turned on at the gas meter.
CONNECTING
TO GAS SUPPLY
INSTALLATION INSTRUCTIONS
Remove the two screws on the gas access cover plate as shown below.