Seite 28 von 32
4. When the
- indicator on the control element lights up, the appliance signals that
the water tank is empty.
a. In this case, fill the tank, proceeding as described in the section "Preparing the
humidification unit" under "Commissioning".
NOTE
Use distilled water, do not use oils, alcohols or chemicals.
NOTE
Do not cover the outlet from which the steam flows!
NOTE
The humidification function can be used in all modes.
MAINTENANCE AND CLEANING
Clean the appliance (every 2 weeks)
Before cleaning, switch off the appliance, wait a few minutes and then always unplug the
appliance from the electrical mains.
Clean the unit with a moderately damp soft cloth and then wipe it with a dry soft cloth.
For safety reasons, never clean the appliance with water. This could be dangerous.
Never use petrol, alcohol or solvents for cleaning.
Do not spray insecticides or similar agents on the air purifier.
Cleaning the pre-filter (every 2 weeks)
To remove the dust accumulated in the pre-filter, use a hoover.
If the pre-filter is very dirty, you can immerse it in hot water and rinse it several times
however, the water temperature should not exceed 40°C.
After washing, allow the air filter to dry out well and then replace them.
NOTE
Never use the appliance without the pre-filter. Do not insert the filter until it is completely dry.
Cleaning of the HEPA & activated carbon filter (every 2 weeks)
To remove the dust accumulated on the outside of the filter, use a hoover.
Remove the filter and place it in a well-ventilated place outside the living area for 12
hours.
This allows particles and substances accumulated in the filter to escape from the
filter.
