BDS AirMAB 5000, Руководство по эксплуатации

Страница: 14 / 19

13
Use
AirMAB 5000
GB
Use
Activating/deactivating the mag-
netic clamp
Activating the magnetic clamp
Turn the lever for the permanent
‹
magnet (11) to the right (ON position)
to activate the magnets.
Deactivating the magnetic clamp
Hold the handle tightly (5) to stop the
‹
machine from slipping.
Push the locking button (12) and turn
‹
the lever (11) for the magnetic clamps
to the left (OFF position) to release the
magnets.
Switching the machine ON/OFF
Switching on the machine
Turn the motor switch (10) to the ON
‹
position to activate the motor.
Switching off the machine
Turn the motor switch (10) to the OFF
‹
position to deactivate the motor.
WARNING
Risk of injury from motor starting
unintentionally!
Pay attention to the following safety
notes to avoid danger from motor starting
unintentionally:
To completely stop the motor:
►
Move the motor switch to the OFF
position.
Disconnect the compressed air sup-
ply.
Drilling with the machine
Drilling with core drills
When drilling with core drills, proceed as
follows:
Mount the KEYLESS quick-change
‹
drill chuck system (A).
Install the appropriate ejector pin
‹
in the core drill and insert the core
drill into the quick-change drill chuck
system.
Place the machine at the working loca-
‹
tion, align it and switch on the mag-
netic clamps.
NOTE
Observe the following instructions when
drilling with core drills:
Drilling with core drills does not re-
►
quire great force. The drilling process
is not accelerated by higher pres-
sure. The drill wears faster and the
machine can be overloaded.
Use the pump bottle for cutting oil/
►
drilling emulsion (21) with BDS 5000
high-performance cutting oil supplied
for the machine.
When working overhead, use
►
ZHS 400 high-performance grease
spray. Spray the drill with grease
spray on the inside and outside
before drilling. Repeat this procedure
when drilling deeper holes.
Make sure that swarf is removed
►
regularly. With larger drilling depths,
break the chip.