Figure 2-4
Then please follow Figure 2-5 to insert the power pin, video/control pin, alarm cable
pin to the corresponding sockets in the outlet.
Note:
Please make sure the power is disconnected when you connect the power cable.
After you connected the cable to the power, please check LED light in the power
panel is on or not. You can refer to the error definition sheet for detailed information.
Do remember fixing the captive screws after you closed the panel.
11
Figure 2-5
Power
Video/Control
Alarm
Heating Strap
2.2.3 Camera
Installation
Pull the camera out of the package. Please check there is any visible damage or not.
Please refer to user’s manual for dial switch SW2 and SW1 setup. Now you have set
the speed dome baud rate, control protocol and speed dome address. See Figure
2-6.
SW1
SW2
Figure 2-6
