GB.4-V2
POWER LOW
2.
Make sure you have put 4 pcs
of 1.5V battery into the battery
chamber. Oxyride batteries are
not recommended because of the initial 1.7 Volt output.
If the 1.5V battery runs out of power, screen will show
“REPLACE INTERNAL BATTERY” or” POWER LOW”.
Replace the 4pcs 1.5V batteries before starting the test.
Note that nothing will be seen on the display until
the tester is connected to a vehicle battery.
3.
Make sure the battery terminals are clean. Wire brush
them if necessary. Clamp the black load lead to the
vehicle negative battery terminal. Clamp the red load
lead to the vehicle positive battery terminal. Please
clamp on the lead part of the terminal only. Clamping on
the iron part of the terminal will lead to wrong test
results.
4.
Paper load: Open the clear cover. Insert paper to the
paper feeding for auto running the paper into printer..
Step 1: connect the clamps to
the teste battery
Step 2: open the clear cover
Step 3: insert the paper into
the paper feeding
