Installation Manual – Rx100 Interface Edition 1.5
March 2001
Page 3
1. PRE-INSTALLATION CHECKS AND SAFETY PROCEDURES
UNPACKING
Check Packaging -
Upon taking delivery of the unit, inspect the packaging for signs of damage. If
damage has occurred, advise the carriers and/or the suppliers immediately.
Check Contents -
Upon taking delivery of the unit, unpack the unit carefully and check that all the
items are present and correct. If any items are missing or damaged, contact your equipment dealer.
Retain Packaging -
The shipping carton is the safest container in which to transport the unit.
Retain undamaged packaging for possible future use.
IMPORTANT SAFETY PRECAUTIONS
Read Instructions -
All relevant safety, installation and operating instructions should be read before
attempting to install, connect or operate the unit.
Retain Instructions -
All safety, installation and operating instructions should be retained for future
reference.
Heed Warnings -
All warnings on the unit and in any relevant safety, installation or operating
instructions should be adhered to.
Cleaning -
Unplug the unit from the power outlet before cleaning. Do not use liquid cleaners or
aerosol cleaners. Use a damp cloth for cleaning.
Attachments -
Do not use attachments not recommended by the product manufacturer as they may
cause hazards.
Water and Moisture -
Do not expose the internal electronics of this unit to water or dampness; for
example, in an unprotected outdoor installation, or in any area classified as a wet location. The unit
as supplied conforms to ingress protection rating IP 67. This rating will be affected by any holes
made in the enclosure. Cable entry points should be protected by the use of suitably rated glands
and/or flexible conduit. It is not necessary to make further holes in the enclosure for mounting
purposes, as mounting holes are provided at the corners of the enclosure outboard of the seal
between enclosure and lid.
Accessories -
Do not attach this unit to an unstable stand, bracket or mount. The unit may fall,
causing serious injury to a person and serious damage to the unit.
Power Sources -
This unit should be operated only from the type of power source indicated on the
manufacturer’s label. If you are not sure of the type of power supply you intend to use, consult your
equipment dealer or local power company. For units intended to operate from battery power or
other sources, refer to operating instructions.
Power Connector -
This unit is equipped with coaxial power connector mounted at the edge of the
PCB for low voltage power input. Do not attempt to alter this connector in any way.
Power Cord Protection -
Power supply cords should be routed so that they are not likely to be
trapped, pinched or otherwise damaged by items in close proximity to them, whether inside the unit
or outside it. Particular attention should be paid to cords at plugs, connection units and the point of
exit from the unit.
Overloading -
Do not overload outlets and extension cords, as this can result in fire or electric
shock.
Object and Liquid Entry -
Never push objects of any kind into the unit, as they may touch
dangerous voltage points or short out parts that could result in fire or electric shock. Never spill
liquid of any kind on or inside the unit.
Servicing -
Servicing of the unit should only be undertaken by qualified service personnel, as
opening or
removing covers may expose you to dangerous voltages or other hazards.
