BBV BBV RX100, Руководство по установке

Страница: 18 / 20

Rx100 manual Appendix A – Dome connections Page A-8
FEATURES
The Rx100 provides the following features.
Tx400DC Tx1000DC
Pan/Tilt Joystick Joystick
Zoom Zoom keys Zoom keys
Focus Focus keys Focus keys
Iris Iris keys Iris keys
Save pre-set
Hold PROGRAM
&
tap 1 - 8 Press PROGRAM then 1 then 1-16
Goto pre-set
Tap 1 - 8 Hold PRESET
&
tap 1 - 16
Start Patrol 1 Hold PROGRAM
&
tap AUTOPAN Hold PATROL
&
tap 1
Start Patrol 2 Hold PROGRAM
&
tap LIGHTS Hold PATROL
&
tap 2
Aux2. Dome
back box
output.
WASH WASH
Dome Menu Hold # & tap 1 Hold # & tap WASH
Note: Very high speed, ‘Turbo mode’ can be enabled when joystick moved to limits by fitting the
OPTION LINK to J6 of Rx100. If the link is removed then standard speeds will be used. Turbo
mode speed is used when responding to an alarm activation.
Local alarm activation 1-4 will drive dome to pre-set position 1-4 if programmed.
Note:
The dome menu is accessed by using the keystrokes shown in the above table. This key sequence
sends a ‘Program Preset 95’ command to the dome which is a special function. The exact menu
structure is explained in the SD5 Installation/Operation Manual.
As an example, the following keystrokes are used to set the maximum zoom ratio to 48. The
example assumes that a Tx1000 is controlling the Rx100. Please use the keystrokes corresponding
to the Tx400dc if that unit is controlling the Rx100.
1. Select the camera to be programmed.
2. Hold # & tap WASH. The display shows:
ð ð
<Camera>
<Line Sync>
<Other>
Exit
3. Press ‘ IRIS OPEN’. The
ð
changes to
-
indicating that this function is selected.
Hold # & tap WASH
4. The Camera menu is now displayed:
ð ð
Backlight comp Off
Zoom limit x96
Reset camera
<Gain/AGC>
<Auto iris>
Next
Exit
5. The
ð
can be moved up & down by either pressing the tilt up & down keys or
moving the joystick up and down. When the
ð
is beside the Zoom limit line, press
‘ IRIS OPEN’, the
ð
will change to
-
indicating that this function is selected. Hold #
& tap WASH.
6. The Zoom limit line now shows:
-
Zoom limit
ð ð
x96 . The zoom ratio can be
changed by either pressing the up and down keys or moving the joystick up and
down. When the correct value is displayed press ‘
OPEN IRIS’ to select this value.
Hold # & tap WASH.
7. To exit from the menu, move the
ð
down to Exit and press ‘OPEN IRIS’ and then
Hold # & tap WASH.
8. Repeat step 7 to exit completely and return to normal operation.
Please refer to the Pelco documentation for a complete description of available menu settings.
The above function is available with Rx100 software Revision 2 and later. Please contact BBV for a
software upgrade if required.