W W W . B B K P E R F O R M A N C E . C O M
FOLLOw THESE INSTRUCTIONS CAREFULLY TO ENSURE CORRECT FITMENT AND OPERATION
27427 BOSTIK COURT
TEMECULA, CA 92590
For any questions, email us:
IMPORTANT: All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.
BBK Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product.
UPDATED LAST: June 2018
MADE IN U.S.A.
STEP 11
Check the rubber hanger on the exhaust system for proper placement after
moving the exhaust back and forth, to be sure none of them are falling or
came off.
STEP 12
Lower the vehicle down and re-install the dip stick tube.
NOTE!!! On 2009-2014 use the supplied spacer and longer header bolt, re-
install the dip stick tube on the top front header bolt hole as shown above.
STEP 13
Re-connect the negative battery terminal. Start the engine and check for any
leaks. Header bolts should be re-tightened after 100 miles of driving.
STEP 10
Now work the exhaust forward: torque the headers and installed supplied
hardware. Notice in the picture on driver-side we supplied 1pc X 2 inch long
bolt and 3pcs X 2 ½ Inch long bolts. Use the shorter 2 inch on the in-side of
the elbow area. Now tighten exhaust down evenly and re-connect 02 sensor
plugs.
