W W W . B B K P E R F O R M A N C E . C O M
FOLLOw THESE INSTRUCTIONS CAREFULLY TO ENSURE CORRECT FITMENT AND OPERATION
27427 BOSTIK COURT
TEMECULA, CA 92590
For any questions, email us:
IMPORTANT: All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.
BBK Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product.
UPDATED LAST: June 2018
MADE IN U.S.A.
DRIVERS SIDE
STEP 8
On the driver side, the steering shaft needs to be unbolted and moved to the
side and the engine needs to be lifted. Install the supplied gasket and BBK
Header into place and tighten in an X-pattern.
NOTE!!! On 2009-2014 Models Leave the front top hole with no bolt. The
longer header bolt that is supplied will be used when re-installing the dip
stick tube.
STEP 6
To aid in the installation, the 2 rear bottom bolts need to be threaded halfway
into the head because the tight fit of the tube will not allow them to be
installed after the header is fully on. This needs to be done on both sides of
the engine. Use the provided header bolts. You can install the gaskets on the
head and hold them down with the pre-installed bolts.
PASSENGER SIDE
STEP 7
On the passenger side the engine needs to be lifted a bit to install the header.
Loosen the motor mount bolt and raise the engine. Install the supplied gasket
and BBK header and then lower the engine back down. Tighten all the header
bolts from center out in an X-pattern.
