UPDATED LAST: June 2018
W W W . B B K P E R F O R M A N C E . C O M
27427 BOSTIK COURT
TEMECULA, CA 92590
For any questions, email us:
IMPORTANT: All appropriate safety equipment and gear must be used during the installation of this or any BBK Performance products or any time you work on a vehicle.
BBK Performance Inc. accepts no responsibility for injuries or damage caused by or during the installation of this product.
MADE IN U.S.A.
STEP 1
Disconnect the negative battery terminal. Lift the vehicle as high as possible.
STEP 2
Unplug the 4 oxygen sensor plugs coming off the front and rear of the mid-
pipe section.
STEP 3
Unbolt the downpipes/cats from the exhaust manifolds. Using a pry bar, slide
the whole exhaust system back on the metal rod hangers. Move it back far
enough that the exhaust manifolds can be removed. It just takes a few inches
and its out of the way.
NOTE!!! Be sure to use WD-40 on the hangers to allow the exhaust system
to slide back easier.
STEP 4
Remove the four nuts that hold the heat shields to the exhaust manifolds and
remove them.
STEP 5
Unbolt both exhaust manifolds and remove from the vehicle. Also remove the
stock gaskets.
