23
Type the desired debounce delay time followed by <ENTER>. The debounce
delay is used to guard against erroneous events. An event will not be valid unless
the input channel has remained at a changed state for the debounce duration.
If you type "2" from the "Sampling Setup" menu shown on the previous page
(Latch Polarity), the PDI will respond with the following:
SET LATCH POLARITY
Latch Polarity..................HI TO LO
Low to Hi Transitions only......1
Hi to Low Transitions only......2
Exit............................X
Enter Selection:
Enter the desired Latch Polarity. The Latch Polarity is used to latch initial events
for individual inputs based on a positive going (LO to HI) or negative going (HI to
LO) input.
5.1.4
REPORTING SETUP
By responding to the
Enter Selection:
message at the end of the Configuration
Main Menu (see
Section 5.1.1
) with "3" (Reporting Setup), you may program how
the PDI reports event samples to the host device. The items you may program are
Reporting Method
,
Report Start Time
,
Report Interval
,
Host Address
,
Data
Format
,
Time Tag
, and
Terminating Character(s)
. The operational functionality of
these items is discussed in
Section 4.2.2
. The PDI will respond with the Reporting
Setup menu as follows:
REPORTING SETUP
Reporting Method...................1
Report Start Time..................2
Report Interval....................3
Host Address.......................4
Time Tag...........................5
Terminating Character(s)...........6
Exit...............................X
Enter Selection:
Содержание V79 PDI-1
