Page
16
Change ATS Delay Switch to Secondary
Select 8), from the configure menu
to allow the user to set the delay time the unit switches to the
Secondary Input once the Primary input drops below the Loss of Power Threshold.
Default is
Disabled, and Default time is 0-seconds
. This time can be adjusted from 1-255 seconds.
If this feature is already enabled, you get the question below. Type
‘Y’
and press Enter to disable the
feature and you will be sent back to the ‘config’ menu. Type
‘N’
and press Enter. The unit will
display the current switch time and ask if you want to change the time. Type
‘N’
and press Enter and
you will be sent back to the ‘config’ menu. Type
‘Y’
and press Enter. You will be asked to enter a
time of (1-255) seconds.
Enter Request: 8
Disable delay switch to secondary (Y/N)? N
Current delay switch to secondary source time is: 3 Seconds
Change delay switch to secondary time (Y/N)? Y
Enter seconds (1-255):
Enter Request: 8
Disable delay switch to secondary (Y/N)? Y
Enter Request:
Type
‘N’
and press Enter. The unit will display the current switch time and ask if you want to change
the time. Type
‘N’
and press Enter and you will be sent back to the ‘config’ menu. Type
‘Y’
and press
Enter. You will be asked to enter a time of (1-255) seconds.
If this feature is already
Enabled
, you get the question below. Type
‘N’
and press Enter to disable the
feature and you will be sent back to the ‘config’ menu. Type
‘Y’
and press Enter. The unit will
display the current switch time and ask if you want to change the time. Type
‘N’
and press Enter and
you will be sent back to the ‘config’ menu. Type
‘Y’
and press Enter. You will be asked to enter a
time of (1-255) seconds.
Enter Request: 8
Enable delay switch to secondary (Y/N)? y
Current delay switch to secondary source time is: 60 Seconds
Change delay switch to secondary time (Y/N)? Y
Enter seconds (1-255): 30
