F/W Version 2.1
, 2013
17
12.14.
Stick Deadband
The dead band is the range around the very center of the stick at where
A3X Pro E. will not
react. Some transmitters have the problem that when the sticks are brought back after an
input, they are not exactly at the same center position as before which may generate a
deviation on the corresponding function, although the sticks seems to be in the middle.
The parameter can be adjusted between 0% and 10%, the default is 5%. You can set it higher if it is difficult to
find the stick center position even the stick centering function has been applied already.
12.15.
System Menu
12.15.1.
Data Save
In order to make a backup or sharing of the settings, you can save 5 copies of the data into the internal memory
within the program card. Press UP/+ or DN/- buttons to select the corresponding archive and press ENT to save
them. * indicate the saved archive, data will be overwritten if saving it again.
12.15.2.
Data Load
It is used to load data from the saved archive within the card, after loaded, the new settings will be written into the
controller immediately. A message of "Data Empty" will be showed when trying to load archives without *.
12.15.3.
Language
See P10 "11.3. Language Selection".
12.15.4.
Device Info.
The device name and the current firmware version number of the controller can be
found here.
12.15.5.
Card Info.
The current firmware version number of the program card can be found here.
HTTP://WWW.BAY-TEC.DE
Sept. 12, 2013
