F/W Version 2.1
16
12.13.
Stick Centering
Stick centering is used to calibrate and remember the center pulse width of receipt signal. The controller has to
re-learn the new center position of the sticks in the conditions as following:
In what conditions a stick centering should be needed?
1
First-time use or after installation.
2
After replacing a new radio system.
3
After making a trimming or sub-trim change within the transmitter.
4
If the servos move to one side automatically when switching to 3D flight mode.
e.g. How to perform centering?
Step 1
Get the controller connected from receiver by the corresponding channels first.
Step 2
Turn on the transmitter, keep all the sticks in the center position.
Step 3
Power on the controller and receiver , get it ready to work.
Step 4
Plug the program card into the controller and select the function Stick Centering, press the ENT
button to start, the card will display "Calibrating..." and the LED will keep flashing GREEN rapidly for
about 1 second.
While calibrating please don't move the sticks until calibration is done
. The stick
centering is only for the channels connected, the unconnected ones or the switch channels will be ignored
automatically during calibrating.
HTTP://WWW.BAY-TEC.DE
Sept. 12, 2013
