6
E
The Fireplace/Heater Remote Control
A great feature of the Fireplace/Heater unit is the small remote control. This remote combines all the functions of the
front panel controls of the fireplace/heater with the convenience of not having to leave the comfort of your seat to
change the settings of the fireplace/heater.
Follow the steps below to install the batteries into the remote control.
1.
Take off the back cover from the battery compartment.
2.
Insert two provided AAA batteries into the battery compartment making sure that the ends of the batteries with the
negative (-) symbols are against the springs in the battery compartment.
3.
Replace the battery compartment cover.
4.
Turn the remote over and aim it towards the fireplace/heater unit.
5.
Press the upper center power button, and see if the flames on the fireplace/heater turn on or off.
6.
If nothing appears to happen, check to make sure the battery is installed correctly, and try again.
Battery Replacement
NOTE:
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon zinc), or rechargeable (nicad, nimh, etc.) batteries.
USING THE REMOTE CONTROL
Do not ingest batteries.
1.
Non-rechargeable batteries are not to be recharged.
2.
Batteries are to be inserted with the correct polarity.
3.
Exhausted batteries are to be removed from the product.
4.
Always purchase the correct size and grade of battery most
suitable for the intended use.
5.
Replace all batteries of a set at the same time.
6.
Clean the battery contacts and also those of the device prior
to battery installation.
7.
Remove batteries from equipment with is not to be used for
an extended period of time.
NOTE:
Battery disposal
Please always dispose of batteries
at a suitable recycling point.
Figure 5
1
2
1
2
